HP 6125XLG R2306-HP 6125XLG Blade Switch High Availability Configuration Guide - Page 26
Displaying and maintaining CFD, CFD configuration example, Network requirements
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Step Command Remarks cfd linktrace service-instance 1. Find the path between a instance-id mep mep-id { target-mac source MEP and a target MEP. mac-address | target-mep Available in any view. target-mep-id } [ ttl ttl-value ] [ hw-only ] 2. Enter system view. system-view N/A 3. Enable LT messages automatic cfd linktrace auto-detection [ size sending. size-value ] By default, LT messages automatic sending is disabled. Displaying and maintaining CFD Execute display commands in any view. Purpose Display LTR information received by a MEP. Display the content of the LTR messages received as responses to the automatically sent LTMs. Display MD configuration information. Display the attribute and running information of the MEPs. Display MEP list in a service instance. Display MP information. Display information about a remote MEP. Display service instance configuration information. Display CFD status. Command display cfd linktrace-reply [ service-instance instance-id [ mep mep-id ] ] display cfd linktrace-reply auto-detection [ size size-value ] display cfd md display cfd mep mep-id service-instance instance-id display cfd meplist [ service-instance instance-id display cfd mp [ interface interface-type interface-number ] display cfd remote-mep service-instance instance-id mep mep-id display cfd service-instance [ instance-id ] display cfd status CFD configuration example Network requirements As shown in Figure 5: • The network comprises five devices and is divided into two MDs: MD_A (level 5) and MD_B (level 3). All ports belong to VLAN 100, and the MAs in the two MDs all serve VLAN 100. Assume that the MAC addresses of Device A through Device E are 0010-FC00-6511, 0010-FC00-6512, 0010-FC00-6513, 0010-FC00-6514, and 0010-FC00-6515, respectively. • MD_A has three edge ports: Ten-GigabitEthernet 1/1/5 on Device A, Ten-GigabitEthernet 1/1/7 on Device D, and Ten-GigabitEthernet 1/1/8 on Device E, and they are all inward-facing MEPs. MD_B has two edge ports: Ten-GigabitEthernet 1/1/7 on Device B and Ten-GigabitEthernet 1/1/5 on Device D, and they are both outward-facing MEPs. 21