HP 6125XLG R2306-HP 6125XLG Blade Switch High Availability Configuration Guide - Page 78
Network diagram
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
Figure 23 Network diagram Virtual IPv6 address: FE80::10 XGE1/1/5 1::10/64 Vlan-int2 FE80::1 1::1/64 Gateway: 1::10/64 Host A Switch A XGE1/1/5 Vlan-int2 FE80::2 1::2/64 Internet Switch B Host B Configuration procedure 1. Configure Switch A: # Configure VLAN 2. system-view [SwitchA] vlan 2 [SwitchA-vlan2] port ten-gigabitethernet 1/1/5 [SwitchA-vlan2] quit [SwitchA] interface vlan-interface 2 [SwitchA-Vlan-interface2] ipv6 address fe80::1 link-local [SwitchA-Vlan-interface2] ipv6 address 1::1 64 # Create VRRP group 1, and set its virtual IPv6 addresses to FE80::10 and 1::10. [SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip fe80::10 link-local [SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip 1::10 # Assign Switch A a higher priority than Switch B in VRRP group 1, so Switch A can become the master. [SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 priority 110 # Configure Switch A to operate in preemptive mode, so it can become the master whenever it operates properly, and set the preemption delay to 5 seconds to avoid frequent status switchover. [SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 preempt-mode delay 5 # Enable Switch A to send RA messages, so Host A can learn the default gateway address. [SwitchA-Vlan-interface2] undo ipv6 nd ra halt 2. Configure Switch B: # Configure VLAN 2. system-view [SwitchB] vlan 2 [SwitchB-vlan2] port ten-gigabitethernet 1/1/5 [SwitchB-vlan2] quit [SwitchB] interface vlan-interface 2 [SwitchB-Vlan-interface2] ipv6 address fe80::2 link-local [SwitchB-Vlan-interface2] ipv6 address 1::2 64 73