HP 6125XLG R2306-HP 6125XLG Blade Switch High Availability Configuration Guide - Page 81
Network diagram
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Figure 24 Network diagram Configuration procedure 1. Configure Switch A: # Configure VLAN 2. system-view [SwitchA] vlan 2 [SwitchA-vlan2] port ten-gigabitethernet 1/1/5 [SwitchA-vlan2] quit [SwitchA] interface vlan-interface 2 [SwitchA-Vlan-interface2] ipv6 address fe80::1 link-local [SwitchA-Vlan-interface2] ipv6 address 1::1 64 # Create VRRP group 1, and set its virtual IPv6 addresses to FE80::10 to 1::10. [SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip fe80::10 link-local [SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip 1::10 # Assign Switch A a higher priority than Switch B in VRRP group 1, so Switch A can become the master in the group. [SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 priority 110 # Enable Switch A to send RA messages, so hosts in VLAN 2 can learn the default gateway address. [SwitchA-Vlan-interface2] undo ipv6 nd ra halt [SwitchA-Vlan-interface2] quit # Configure VLAN 3. [SwitchA] vlan 3 [SwitchA-vlan3] port ten-gigabitethernet 1/1/6 [SwitchA-vlan3] quit [SwitchA] interface vlan-interface 3 [SwitchA-Vlan-interface3] ipv6 address fe90::1 link-local [SwitchA-Vlan-interface3] ipv6 address 2::1 64 # Create VRRP group 2, and set its virtual IPv6 addresses to FE90::10 and 2::10. [SwitchA-Vlan-interface3] vrrp ipv6 vrid 2 virtual-ip fe90::10 link-local 76