HP 6125XLG R2306-HP 6125XLG Blade Switch High Availability Configuration Guide - Page 64
Network diagram, Con Switch B
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Figure 20 Network diagram Configuration procedure 1. Configure Switch A: # Configure VLAN 2. system-view [SwitchA] vlan 2 [SwitchA-vlan2] port ten-gigabitethernet 1/1/5 [SwitchA-vlan2] quit [SwitchA] interface vlan-interface 2 [SwitchA-Vlan-interface2] ip address 10.1.1.1 255.255.255.0 # Create VRRP group 1 on VLAN-interface 2, and set its virtual IP address to 10.1.1.111. [SwitchA-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.111 # Assign Switch A a higher priority than Switch B in VRRP group 1, so Switch A can become the master. [SwitchA-Vlan-interface2] vrrp vrid 1 priority 110 # Configure Switch A to operate in preemptive mode, so it can become the master whenever it operates properly, and set the preemption delay to 5 seconds to avoid frequent status switchover. [SwitchA-Vlan-interface2] vrrp vrid 1 preempt-mode delay 5 2. Configure Switch B: # Configure VLAN 2. system-view [SwitchB] vlan 2 [SwitchB-Vlan2] port ten-gigabitethernet 1/1/5 [SwitchB-vlan2] quit [SwitchB] interface vlan-interface 2 [SwitchB-Vlan-interface2] ip address 10.1.1.2 255.255.255.0 # Create VRRP group 1 on VLAN-interface 2, and set its virtual IP address to 10.1.1.111. [SwitchB-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.111 # Configure the priority of Router B in VRRP group 1 as 100. [SwitchB-Vlan-interface2] vrrp vrid 1 priority 100 # Configure Switch B to operate in preemptive mode, and set the preemption delay to 5 seconds. 59