HP 6125XLG R2306-HP 6125XLG Blade Switch High Availability Configuration Guide - Page 85
Con Switch C, Con the VFs in VRRP group 1 to monitor track entry 1
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
[SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 priority 120 # Configure Switch A to operate in preemptive mode, so it can become the master whenever it operates properly. Set the preemption delay to 5 seconds to avoid frequent status switchover. [SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 preempt-mode delay 5 # Enable Switch A to send RA messages, so hosts on subnet 1::/64 can learn the default gateway address. [SwitchA-Vlan-interface2] undo ipv6 nd ra halt [SwitchA-Vlan-interface2] quit # Create track entry 1 to monitor the upstream link status of VLAN-interface 3. When the upstream link fails, the track entry transits to Negative. [SwitchA] track 1 interface vlan-interface 3 # Configure the VFs in VRRP group 1 to monitor track entry 1, and decrease their weights by 250 when the track entry transits to Negative. [SwitchA] interface vlan-interface 2 [SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 weight track 1 reduced 250 2. Configure Switch B: # Configure VLAN 2. system-view [SwitchB] vlan 2 [SwitchB-vlan2] port ten-gigabitethernet 1/1/5 [SwitchB-vlan2] quit # Configure VRRP to operate in load balancing mode. [SwitchB] vrrp ipv6 mode load-balance # Create VRRP group 1, and set its virtual IPv6 addresses to FE80::10 and 1::10. [SwitchB] interface vlan-interface 2 [SwitchB-Vlan-interface2] ipv6 address fe80::2 link-local [SwitchB-Vlan-interface2] ipv6 address 1::2 64 [SwitchB-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip fe80::10 link-local [SwitchB-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip 1::10 # Assign Switch B a higher priority than Switch C in VRRP group 1, so Switch B can become the master when Switch A fails. [SwitchB-Vlan-interface2] vrrp ipv6 vrid 1 priority 110 # Configure Switch B to operate in preemptive mode, and set the preemption delay to 5 seconds. [SwitchB-Vlan-interface2] vrrp ipv6 vrid 1 preempt-mode delay 5 # Enable Switch B to send RA messages so hosts on subnet 1::/64 can learn the default gateway address. [SwitchB-Vlan-interface2] undo ipv6 nd ra halt [SwitchB-Vlan-interface2] quit # Create track entry 1 to monitor the upstream link status of VLAN-interface 3. When the upstream link fails, the track entry transits to Negative. [SwitchB] track 1 interface vlan-interface 3 # Configure the VFs in VRRP group 1 to monitor track entry 1, and decrease their weights by 250 when the track entry transits to Negative. [SwitchB] interface vlan-interface 2 [SwitchB-Vlan-interface2] vrrp ipv6 vrid 1 weight track 1 reduced 250 3. Configure Switch C: 80