HP 6125XLG R2306-HP 6125XLG Blade Switch High Availability Configuration Guide - Page 71
Con Switch B
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
[SwitchA] interface vlan-interface 2 [SwitchA-Vlan-interface2] vrrp vrid 1 weight track 1 reduced 250 2. Configure Switch B: # Configure VLAN 2. system-view [SwitchB] vlan 2 [SwitchB-vlan2] port ten-gigabitethernet 1/1/5 [SwitchB-vlan2] quit # Configure VRRP to operate in load balancing mode. [SwitchB] vrrp mode load-balance # Create VRRP group 1, and set its virtual IP address to 10.1.1.1. [SwitchB] interface vlan-interface 2 [SwitchB-Vlan-interface2] ip address 10.1.1.3 24 [SwitchB-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.1 # Assign Switch B a higher priority than Switch C in VRRP group 1, so Switch B can become the master when Switch A fails. [SwitchB-Vlan-interface2] vrrp vrid 1 priority 110 # Configure Switch B to operate in preemptive mode, and set the preemption delay to 5 seconds. [SwitchB-Vlan-interface2] vrrp vrid 1 preempt-mode delay 5 [SwitchB-Vlan-interface2] quit # Create track entry 1 to monitor the upstream link status of VLAN-interface 3. When the upstream link fails, the track entry transits to Negative. [SwitchB] track 1 interface vlan-interface 3 # Configure the VFs in VRRP group 1 to monitor track entry 1, and decrease their weights by 250 when the track entry transits to Negative. [SwitchB] interface vlan-interface 2 [SwitchB-Vlan-interface2] vrrp vrid 1 weight track 1 reduced 250 3. Configure Switch C: # Configure VLAN 2. system-view [SwitchC] vlan 2 [SwitchC-vlan2] port ten-gigabitethernet 1/1/5 [SwitchC-vlan2] quit # Configure VRRP to operate in load balancing mode. [SwitchC] vrrp mode load-balance # Create VRRP group 1, and set its virtual IP address to 10.1.1.1. [SwitchC] interface vlan-interface 2 [SwitchC-Vlan-interface2] ip address 10.1.1.4 24 [SwitchC-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.1 # Configure Switch C to operate in preemptive mode, and set the preemption delay to 5 seconds. [SwitchC-Vlan-interface2] vrrp vrid 1 preempt-mode delay 5 [SwitchC-Vlan-interface2] quit # Create track entry 1 to monitor the upstream link status of VLAN-interface 3. When the upstream link fails, the traffic entry transits to Negative. [SwitchC] track 1 interface vlan-interface 3 66