HP D7560 User Guide - Page 134

A blank page came out while printing Try the following solutions to resolve the issue. Solutions are listed in order, with the most likely solution first. If the first solution does not solve the problem, continue trying the remaining solutions until the issue is resolved. • Solution 1: Remove any extra pages or lines at the end of the document • Solution 2: Load paper in the input tray Solution 1: Remove any extra pages or lines at the end of the document Solution: Open the document file in your software application and remove any extra pages or lines at the end of the document. Cause: The document you were printing contained an additional blank page. If this did not solve the issue, try the next solution. Solution 2: Load paper in the input tray Solution: If the product has only a few sheets remaining, load more paper in the input tray. If there is plenty of paper in the input tray, remove the paper, tap the stack of paper against a flat surface, and reload the paper into the input tray. For more information, see: "Load paper" on page 29 Cause: The product picked up two sheets of paper. Ink is spraying the inside of the product when I print a photo Solution: Make sure you load photo paper in the input tray before you print a borderless print job. For more information, see: "Load full-size paper or small-size photo paper" on page 31 Cause: You were using the wrong paper type. The borderless print settings require you to print on photo paper. Memory card troubleshooting Use this section to solve these memory card problems: • My memory card no longer works in my digital camera • The Photo light next to the memory card slots is blinking • The Attention light blinks when I insert my memory card or storage device • The product does not read the memory card • The photos on the memory card do not transfer to my computer • Photos in a connected digital camera with PictBridge do not print Memory card troubleshooting 131 Troubleshooting