HP LH4r HP Netserver DiagTools v1.0x User Guide - Page 67

Chapter 5 Error Message Reference Code 100Eh 100Fh 1010h 1011h Description Recommended Action 4. Be sure the processor board (if any) is seated. 5. Make sure the CPU chip is seated. (Take ESD precautions.) 6. Make sure the memory elements (DIMMs) are properly seated. 7. Check system fans. If overheating occurs, chip may shut down. 8. If the system ran with temperature high, let it cool for 30 minutes, then restart. 9. If system repeatedly shows this error, replace the CPU chip or board, as appropriate. Multi Processor Failure. CPU speed error 1. Reduce the system to its minimum configuration per the technical reference label or card. 2. Make sure the system board is seated. 3. Check the seating of the voltage regulator module (VRM) if present. 4. Be sure the processor board (if any) is seated. 5. Make sure the CPU chip is seated. (Take ESD precautions.) 6. Make sure the memory elements (DIMMs) are properly seated. 7. Check system fans. If overheating occurs, chip may shut down. 8. If the system ran with temperature high, let it cool for 30 minutes, then restart. 9. If system repeatedly shows this error, replace the CPU chip or board, as appropriate. Multi Processor Failure. CPU count error 1. Reduce the system to its minimum configuration per the technical reference label or card. 2. Make sure the system board is seated. 3. Check the seating of the voltage regulator module (VRM) if present. 4. Be sure the processor board (if any) is seated. 5. Make sure the CPU chip is seated. (Take ESD precautions.) 6. Make sure the memory elements (DIMMs) are properly seated. 7. Check system fans. If overheating occurs, chip may shut down. 8. If the system ran with temperature high, let it cool for 30 minutes, then restart. 9. If system repeatedly shows this error, replace the CPU chip or board, as appropriate. Multi Processor Failure. Configuration Access Mechanism Test Failed. 1. Reduce the system to its minimum configuration per the technical reference label or card. 2. Make sure the system board is seated. 3. Check the seating of the voltage regulator module (VRM) if present. 4. Be sure the processor board (if any) is seated. 5. Make sure the CPU chip is seated. (Take ESD precautions.) 6. Make sure the memory elements (DIMMs) are properly seated. 7. Check system fans. If overheating occurs, chip may shut down. 8. If the system ran with temperature high, let it cool for 30 minutes, then restart. 9. If system repeatedly shows this error, replace the CPU chip or board, as appropriate. Multi Processor Failure. TagRAM Control Register Read Failed. 1. Reduce the system to its minimum configuration per the technical reference label or card. 2. Make sure the system board is seated. 3. Check the seating of the voltage regulator module (VRM) if present. 63