HP LH4r HP Netserver DiagTools v1.0x User Guide - Page 68

Chapter 5 Error Message Reference Code 1012h 1013h 1014h 1015h Description Recommended Action 4. Be sure the processor board (if any) is seated. 5. Make sure the CPU chip is seated. (Take ESD precautions.) 6. Make sure the memory elements (DIMMs) are properly seated. 7. Check system fans. If overheating occurs, chip may shut down. 8. If the system ran with temperature high, let it cool for 30 minutes, then restart. 9. If system repeatedly shows this error, replace the CPU chip or board, as appropriate. Multi Processor Failure. TagRAM Control Register Write Failed. 1. Reduce the system to its minimum configuration per the technical reference label or card. 2. Make sure the system board is seated. 3. Check the seating of the voltage regulator module (VRM) if present. 4. Be sure the processor board (if any) is seated. 5. Make sure the CPU chip is seated. (Take ESD precautions.) 6. Make sure the memory elements (DIMMs) are properly seated. 7. Check system fans. If overheating occurs, chip may shut down. 8. If the system ran with temperature high, let it cool for 30 minutes, then restart. 9. If system repeatedly shows this error, replace the CPU chip or board, as appropriate. Multi Processor Failure. Value read back from TagRAM Control Register is not same as the value written. 1. Reduce the system to its minimum configuration per the technical reference label or card. 2. Make sure the system board is seated. 3. Check the seating of the voltage regulator module (VRM) if present. 4. Be sure the processor board (if any) is seated. 5. Make sure the CPU chip is seated. (Take ESD precautions.) 6. Make sure the memory elements (DIMMs) are properly seated. 7. Check system fans. If overheating occurs, chip may shut down. 8. If the system ran with temperature high, let it cool for 30 minutes, then restart. 9. If system repeatedly shows this error, replace the CPU chip or board, as appropriate. Multi Processor Failure. L2 cache Commands Test Failed. 1. Reduce the system to its minimum configuration per the technical reference label or card. 2. Make sure the system board is seated. 3. Check the seating of the voltage regulator module (VRM) if present. 4. Be sure the processor board (if any) is seated. 5. Make sure the CPU chip is seated. (Take ESD precautions.) 6. Make sure the memory elements (DIMMs) are properly seated. 7. Check system fans. If overheating occurs, chip may shut down. 8. If the system ran with temperature high, let it cool for 30 minutes, then restart. 9. If system repeatedly shows this error, replace the CPU chip or board, as appropriate. Multi Processor 1. Reduce the system to its minimum configuration per the technical reference 64