HP OMEN Transcend 16 Maintenance and Service Guide - Page 51
Remove seven Phillips M2.0 × 3.5 screws
View all HP OMEN Transcend 16 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Table 6-6 Touchpad description and part number Description Touchpad for use in ceramic white models Touchpad for use in shadow black models Touchpad cable Spare part number N43744-001 N43743-001 N43719-001 Before removing the touchpad, follow these steps: 1. Prepare the computer for disassembly (see Preparation for disassembly on page 37). 2. Remove the bottom cover (see Bottom cover on page 37). 3. Remove the battery (see Battery on page 39). Remove the touchpad: NOTE: All flat cable connectors are covered with a piece of Mylar to prevent accidental disconnection. Be sure to replace this Mylar during reassembly. 1. The bottom of the system board covers the top of the touchpad. You can lift the bottom of the system board up enough to access the touchpad screws without completely removing the system board: a. Remove seven Phillips M2.0 × 3.5 screws (1) from the system board. b. Remove the four Phillips M2.0 × 5.0 screws (2) from the brackets on the system board. c. Disconnect the five cables (3) from along the bottom of the system board. d. Lift the bottom of the system board up enough to access the touchpad screws (4). 44 Chapter 6 Removal and replacement procedures for authorized service provider parts