HP OMEN Transcend 16 Maintenance and Service Guide - Page 60

IR board, Prepare the computer for disassembly see

Get HP OMEN Transcend 16 PDF manuals and user guides View all HP OMEN Transcend 16 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 60 highlights

2. Remove the fans (2). To install the fans, reverse this procedure. IR board To remove the IR board, use this procedure and illustration. Table 6-12 IR board description and part number Description IR board IR board cable Spare part number N43739-001 N43718-001 Before removing the IR board, follow these steps: NOTE: All flat cable connectors are covered with a piece of Mylar to prevent accidental disconnection. Be sure to replace this Mylar during reassembly. 1. Prepare the computer for disassembly (see Preparation for disassembly on page 37). 2. Remove the bottom cover (see Bottom cover on page 37). 3. Remove the battery (see Battery on page 39). 4. Remove the system board (see System board with heat sink on page 48). Remove the IR board: IR board 53

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
2.
Remove the fans
(2)
.
To install the fans, reverse this procedure.
IR board
To remove the IR board, use this procedure and illustration.
Table 6-12
IR board description and part number
Description
Spare part number
IR board
N43739-001
IR board cable
N43718-001
Before removing the IR board, follow these steps:
NOTE:
All flat cable connectors are covered with a piece of Mylar to prevent accidental
disconnection. Be sure to replace this Mylar during reassembly.
1.
Prepare the computer for disassembly (see
Preparation for disassembly
on page
37
).
2.
Remove the bottom cover (see
Bottom cover
on page
37
).
3.
Remove the battery (see
Battery
on page
39
).
4.
Remove the system board (see
System board with heat sink
on page
48
).
Remove the IR board:
IR board
53