HP Stitch S1000 User Guide - Page 136
Remove the edge holders if they are in use, Clean the platen, Clean the substrate-advance sensor
View all HP Stitch S1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 136 highlights
4. Ensure that all windows, covers, and doors are closed and remain in their original positions. 5. Turn off the printer in the correct way for maintenance operations: see Turn the printer off on page 125. 6. Open the window. Remove the edge holders (if they are in use) 1. Remove the two substrate edge holders from the platen. 2. Replace the edge holder strips if necessary. See Replace an edge holder strip on page 41. Clean the platen 1. Clean the platen with a clean cloth dampened with distilled water. Be very careful not to touch the printheads 2. Check the print zone and remove any dirt, aerosol or ink from the platen. Check the substrate paths, focusing on the bottom-plate zone. Check the print output areas for ink drops, aerosol, or condensation. Clean the substrate edge holders if required. See also General cleaning instructions on page 11. Clean the substrate-advance sensor ▲ See Clean the substrate-advance sensor on page 134. 130 Chapter 11 Hardware maintenance ENWW