HP Stitch S1000 User Guide - Page 257

Text messages (continued) Message Cleaner roll jam. Color calibration cancelled because of scanning errors FW upgrade post actions Initializing Initializing, please wait Ink drying Ink system not ready to print Job canceled due to lack of data received from the IPS Line sensor calib. error: substrate too small Low cleaner roll Lower lever Maintenance #N advised. Please contact HP No substrate loaded Offline Please close safety sensor Please turn emergency stop buttons to release them. Preparing to print Printer cannot carry on printing Printer cannot cool down Printer cannot warm up Printheads not aligned Printhead replacement incomplete Printing Ready Remove {color} printhead Replace {color} cartridge ENWW Recommendation Go to the Internal Print Server and select the Ink System menu, then Check cleaner roll. Pull out the printhead cleaning roll assembly, raise the pinchwheels, wind the roll forward manually, then lower the pinchwheels and push the assembly back into the printer. The color calibration chart could not be scanned successfully with the current substrate. See Color calibration fails on page 242. The firmware update is being performed. The Internal Print Server is connecting to the printer. The Internal Print Server is starting the printer. The printer is drying the last passes of a job after printing it. Wait a while. If the printer does not recover, restart it. If the problem persists, check the configuration of the Internal Print Server computer. Load a larger substrate. Be ready to replace the printhead cleaning roll soon. Lower the substrate pressure handles. You are advised to contact your service representative. See HP Customer Care Centers on page 244. Load substrate. The printer is shut down or not detected. An open safety circuit has been detected, and should be closed in order to continue working. An emergency button has been pressed, and must be released to continue working. The printer is performing checks and warm-up prior to printing. Check that the three-phase power supply is working and that the ambient temperature is within the normal range. This problem can also be caused by holes in the substrate, by reflective or transparent substrates, or by a dirty or faulty temperature sensor. If the ambient temperature is within the normal range, this problem may be caused by removing the substrate too quickly after printing. Try leaving the substrate in the printer until temperatures settle down after printing. Check that the three-phase power supply is working. This problem can also be caused by holes in the substrate, by reflective or transparent substrates, or by a dirty or faulty temperature sensor. Align the printheads. See Align the printheads on page 89. The printhead replacement process was unsuccessful. See The Internal Print Server recommends replacing or reseating a printhead on page 235. The printer is printing. The printer is ready to receive and print a job. Remove the printhead. See Remove a printhead on page 73. Replace the ink cartridge. See The Internal Print Server recommends replacing or reseating an ink cartridge on page 234. 251