HP Visualize b180L hp Visualize workstation b132L, b132L plus, b160L, and b180 - Page 129

Table 15 NOTICE: Changing Your Workstation's Hardware Configuration Installing Storage Devices Preparing to Install Your Storage Device This section describes information that you need to consider and procedures that you need to perform before installing any storage device. Configuring your Storage Device Table 15 lists the recommended SCSI IDs for internal storage devices. If an existing device already uses one of the suggested IDs, select an alternate ID. Default SCSI IDs Fast, Wide SCSI and Ultra Wide SCSI 1st Hard Disk Drive ID 6 2nd Hard Disk Drive ID 5 Note: The Fast, Wide SCSI and Ultra Wide controller is set to SCSI ID 7. Single-Ended SCSI CD-ROM Drive ID 2 DDS Drive ID 3 1st Hard Disk Drive ID 6 2nd Hard Disk Drive ID 5 Notes: The floppy drive is NOT a SCSI device. Each SCSI controller uses SCSI ID 7. The floppy disk drive is not a SCSI device. Set the jumpers and SCSI IDs according to the installation instructions that came with your device. Narrow Single-Ended SCSI can use addresses in the range 0 through 7, with 7 reserved for the controller. Fast, Wide Differential and Ultra, Wide Single-Ended SCSI can use addresses in the range 0 through 15, with 7 reserved for the controller. Determining Your Storage Devices Position Each storage device is restricted as to where in the storage tray it may be installed. Before installing a storage device, use Figure 23 and Table 16 to determine which disk tray position is correct for your device. 115