HP Visualize b180L hp Visualize workstation b132L, b132L plus, b160L, and b180 - Page 157

Changing Your Workstation's Hardware Configuration Installing Additional memory 3 Close the ejector tabs on each side of the memory connector to lessen the force required to seat the memory module, as shown in Figure 47. 4 Line up the memory module with the guides making sure that the notched end of the memory module is toward the white ejector tab (front of the main tray), as shown in Figure 47. Figure 47 White Ejector Tab Installing Memory Modules 5 Press firmly and evenly on the memory module to ensure that it is fully seated. 6 Install the memory retainer. 7 To verify that this installation was successful, follow the steps in Appendix D, "The Boot Console Interface," on displaying memory information. If you have only replaced a faulty memory module, you must issue the pdt clear command in the service menu of the Boot Console Interface. Answer yes (y) to the prompt "Continue? (Y/N) >." 143