HP Visualize b180L hp Visualize workstation b132L, b132L plus, b160L, and b180 - Page 151
Installing Additional memory
View all HP Visualize b180L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 151 highlights
Changing Your Workstation's Hardware Configuration Installing Additional memory Installing Additional memory Before installing memory modules, perform the procedure described in Removing the Main Tray Assembly on page 111. When you have completed changing your workstation's memory configuration perform the procedure described in Replacing the Main Tray Assembly on page 112. Take a moment to read over the following important notes about installing memory. • Before you attempt to install additional memory modules in your B132L/ B132L+/B160L/B180L workstation, use the information described in Appendix D, "Boot Console Interface," to determine the current memory configuration for this workstation. • Read over the steps involved in installing memory modules before you begin. • You must insert memory modules in pairs of equal size. • Modules should be inserted in the lowest numbered memory pair first then in numerical order. For example, install memory in 0A and 0B first, then 1A and 1B, and 2A and 2B. You must also install the largest memory modules first. For example, install 64 Mbyte module pairs, then 32 Mbyte module pairs, then 16 Mbyte module pairs, and so on. Note that the B180L supports the use of 128 Mbyte modules. Refer to Figure 42 for memory pair numbering and location. • When you have finished installing additional memory modules, use the Boot Console Interface to verify that they are seen by the workstation. You may need to remove existing memory modules and move them to a different location when changing your workstation's memory configuration. Use the following procedure to remove memory modules. Use the procedure in the subsection entitled Installing Memory Modules on page 141 to install memory modules. 137