HP Visualize b180L hp Visualize workstation b132L, b132L plus, b160L, and b180 - Page 177
Installing the Optional Fast Wide Differential SCSI, Controller
View all HP Visualize b180L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 177 highlights
NOTE: Changing Your Workstation's Hardware Configuration Installing the Optional Fast Wide Differential SCSI Controller Installing the Optional Fast Wide Differential SCSI Controller Before you can install the FWD SCSI controller (B132L/B160L only) you must perform the procedure described in Removing the Main Tray Assembly on page 111. You cannot use both the Ultra, Wide-SE SCSI and the Fast Wide Differential SCSI option at the same time. Perform the following procedure to install the FWD SCSI controller: 1 Install the three standoffs, as shown in Figure 64. 2 Line up the connector on the FW SCSI controller and the connector on the CPU board while at the same time aligning the standoffs to the holes in the FWD SCSI controller, as shown in Figure 64. Figure 64 Installing the Optional FWD SCSI Controller 163