HP Visualize b180L hp Visualize workstation b132L, b132L plus, b160L, and b180 - Page 226
Setting the Monitor Type at Power
View all HP Visualize b180L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 226 highlights
NOTICE: The Boot Console Interface Displaying and Setting the Monitor Type Setting the Monitor Type at Power On If you replace your workstation's monitor with a different monitor type, and do not set the workstation's graphics parameters by using the monitor command before doing so, you need to perform the following: If your keyboard connects to the PS/2 connector on your system, wait 2 seconds after the Num Lock light flashes near the end of the boot sequence, then press Tab to initiate the automatic monitor selection process. It takes approximately one to two minutes after powering on the workstation before the Num Lock light flashes. The system cycles through all of the available monitor types one at a time. When you can see a message similar to the following clearly and legibly, select that monitor type by pressing Enter. MONITOR INFORMATION Path Slot Head Type Size Freq Class GRAPHICS(0) 0 1 n nnnnxnnnn nnHz Press [RETURN] to select this monitor type (type n of n types). The system queries you to confirm your selection. Press Y to save this monitor type. If you press any key other than Y, the following message is displayed: Monitor type not saved. At this point, the new monitor type is active, but not saved. Because you didn't save the monitor type, the next time you reboot the system the original monitor type will be used. Next, the following message is displayed: To select a new Graphics Monitor Type press the key now, otherwise EXIT by entering any other key (or will time out in 15 seconds)... To restart the monitor selection process, press TAB. 212