HP Visualize b180L hp Visualize workstation b132L, b132L plus, b160L, and b180 - Page 145
Installing a Hard Disk Drive in Position 1 Rear Position
View all HP Visualize b180L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 145 highlights
Changing Your Workstation's Hardware Configuration Installing Storage Devices Installing a Hard Disk Drive in Position 1 (Rear Position) Perform the following procedure to install a hard disk drive in position 1: 1 Align the four feet on the bottom of the drive carrier with the square holes in the storage tray, as shown in Figure 38. Figure 38 Installing a Hard Disk Drive in Position 1 (Rear Position) 2 Set the drive in the storage tray. 3 Connect the power connector and the appropriate SCSI connector to the drive. 4 Push the drive toward the rear of the tray until the locking tab on the drive carrier snaps into place, as shown in Figure 38. 5 Proceed to the section entitled Replacing the Storage Tray Cover on page 132. 131
131
Changing Your Workstation’s Hardware Configuration
Installing Storage Devices
Installing a Hard Disk Drive in Position 1 (Rear Position)
Perform the following procedure to install a hard disk drive in position 1:
1
Align the four feet on the bottom of the drive carrier with the square holes in the
storage tray, as shown in Figure 38.
Figure 38
Installing a Hard Disk Drive in Position 1 (Rear Position)
2
Set the drive in the storage tray.
3
Connect the power connector and the appropriate SCSI connector to the drive.
4
Push the drive toward the rear of the tray until the locking tab on the drive carrier
snaps into place, as shown in Figure 38.
5
Proceed to the section entitled Replacing the Storage Tray Cover on page 132.