HP Visualize b180L hp Visualize workstation b132L, b132L plus, b160L, and b180 - Page 180
Installing the FWD SCSI Cable
View all HP Visualize b180L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 180 highlights
Changing Your Workstation's Hardware Configuration Installing the Optional Fast Wide Differential SCSI Controller 6 Connect the end of FWD SCSI cable to the FWD SCSI controller making sure that the red line on the cable is toward the rear (away from the fans) of the main tray, as shown in Figure 67. To FWD SCSI Controller Red Line External Connector Ferrite Bead Cable Clip Figure 67 Installing the FWD SCSI Cable 7 Set the ferrite bead into the slot on the side of the storage tray. Make sure that the cable is dressed so that it will not be damaged by the storage tray cover 8 Use the two hex standoffs to install the external connector on the end of the FWD SCSI cable into the rear panel of the storage tray, as shown in Figure 67. 9 Secure the cable in the cable clip so that it does not interfere with the disk drives, as shown in Figure 67. 166