HP Workstation x2000 ATI Fire GL 8800 graphics card user guide - Page 16

Installing the Card, Switch off your computer and all external options monitor, printer, and others.

Get HP Workstation x2000 PDF manuals and user guides View all HP Workstation x2000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

12 Installing the Hardware and Software Installing the Card To install your graphics accelerator card, follow these steps: 1 Switch off your computer and all external options (monitor, printer, and others). Then disconnect all cables from the back of your computer. Unplug all power cables from the electrical source. Note: If you are disconnecting a peripheral from the computer or are removing a component from the system board, wait 10 - 20 seconds after disconnecting the computer from the electrical outlet before disconnecting the peripheral or removing the component to avoid possible damage to the system board. To verify that all power has been removed from the system, make sure that the standby power light-emitting diode (LED) on the system board has gone out.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
12
Installing the Hardware and Software
Installing the Card
To install your graphics accelerator card, follow these steps:
1
Switch off your computer and all external options (monitor,
printer, and others).
Then disconnect all cables from the back of
your computer. Unplug all power cables from the electrical source.
Note:
If you are disconnecting a peripheral from the computer or are
removing a component from the system board, wait 10 - 20 seconds
after disconnecting the computer from the electrical outlet before
disconnecting the peripheral or removing the component to avoid
possible damage to the system board.
To verify that all power has
been removed from the system, make sure that the standby power
light-emitting diode (LED) on the system board has gone out
.