Hitachi C4K60 Specifications - Page 70

Word Table 7.8 IDENTIFY DEVICE information(Continued) Description 89 Time required for security erase unit completion Word 89 specifies the time required for the SECURITY ERASE UNIT command to completion. If word 90 is 0000h, the time is not specified. SECURITY ERASE UNIT completion time = value x 2[minutes] 90 Time required for enhanced security erase unit completion Word 90 specifies the time required for the ENHANCED SECURITY ERASE UNIT command to completion. ENHANCED SECURITY ERASE UNIT completion time = value x 2[minutes]. If Word 90 is 0000h, the time is not specified. 91 Current advanced power management level value Word 91 contains the current Advanced Power Management level settings. 92 Master password revision code Word 92 contains the value of the Master password revision code set when the Master Password was last changed. 93 Hardware reset result bit 15 0 (fixed) bit 14 1 (fixed) bit 13 bit 12 - 8 1 = Device detected CBLID- above ViH 0 = Device detected CBLID- below ViL Device 1 hardware reset result. Device 1 clears these bits to zero. Device 1 sets these bits as follows: bit 12 0 = Reserved bit 11 1 = Device 1 asserted PDIAG- bit 10 - 9 These bits indicate how Device 1 determined the device number: 00, 11 = Reserved 01 = A jumper was used 10 = the CSEL signal was used bit 8 1 (Fixed) bit 7 - 0 Device 0 hardware reset result. Device 1 clears these bits to zero. Device 0 sets these bits as follows: bit 7 0 = Reserved bit 6 1 = Device 0 responds when Device 1 is selected bit 5 1 = Device 0 detected the assertion of DASP- bit 4 1 = Device 0 detected the assertion of PDIAG0 bit 3 1 = Device 0 passed diagnostic bit 2 - 1 These bits indicate how Device 0 determined the device number: 00, 11 = Reserved 01 = A jumper was used 10 = the CSEL signal was used bit 0 1 (Fixed) Value (HEX.) 00XXh 00XXh 40XXh XXXXh XXXXh K6610170 Rev.2 Dec 22, 2004 - 70 -