IBM 4247-003 Maintenance Manual - Page 112

Table 15. MAP 0190: Forms Feed Problems (continued) Step Questions/Actions Yes No 16. Power off (O) the printer. If the rear paper door does not stay open, remove the door from the printer. Remove the rear tractor from the printer. To configure the tractor for rear push mode: v Place the tractor face down on a flat surface with the electrical connector tab on the right side, pointing toward you. v Pull the bottom release levers toward you with your finger tips and push the movable edge of the tractor down toward the flat surface with your thumbs (1) until the tractor locks in the fully extended position (2). 1 2 1 2 Rear Tractor - Push Mode (straight) Rear Tractor - Pull Mode (bent) To configure the tractor for rear pull mode: v Place the tractor face down on a flat surface with the electrical connector tab on the right side, pointing toward you. v Pull the bottom release levers toward you with your finger tips and pull the movable edge of the tractor up away from the flat surface with your thumbs (1) until the tractor locks in the angled position (2). The following figure shows the Rear Tractor in Pull Mode. Retry the failing print job. You have completed this MAP. 17. Are the forms sticking together or sticking to the plastic covers? Static electricity is present in the forms. Contact Level 2 Support for guidance. Go to step 18 on page 113. Go to step 18 on page 113. Chapter 1. Diagnosing Problems 112