IBM 4247-003 Maintenance Manual - Page 384
Model 001/002 Logic Board Jumper Location
View all IBM 4247-003 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 384 highlights
Note: When the non-metal washer is not installed, the frame ground is connected to the dc ground. The default is washer installed. 3. The NPS 540+ can be used without an external power supply only if +5 V dc is enabled (supplied) on pin 18 of the printer parallel attachment connector. NPS devices (p/n 30H4082, 30H4083, 30H4055) cannot be powered by pin 18 and always require an external +12 V ac power supply. There is no danger of damaging any NPS or other computer devices when +5 V dc is enabled on pin 18. The new logic board you will receive will have a 2 pin jumper installed on either a 2 pin or a 3 pin connector located near the parallel attachment connector. To attach the NPS Ethernet 540+ (p/n 30H4054) to the 4247 printer without an external power supply: a. Find the 2 pin jumper and connector. b. If a 2 pin jumper is installed on a 2 pin connector then + 5 V dc is enabled to pin 18. c. If a 2 pin jumper is installed on a 3 pin connector, as shown in Figure 4-18, use the chart below and verify the jumper is installed to enable +5 V dc on pin 18. If the jumper is not installed correctly, move it to the pins shown in the chart. 123 Logic Board Parallel Connector Figure 123. Model 001/002 Logic Board Jumper Location. (Viewed From Rear) Note: If after installing the logic board, the NPS 540+ power light is not lighted, check for + 5 V dc on pin 18 with a volt meter (pin 18 is shown on connector). Chapter 5. Removals and Adjustments 384