IBM 4247-003 Maintenance Manual - Page 176

Note: F.FR ADJ is First print-line FRont tractor ADJustment Front Fanfold Forms Path - To select the test for the front fanfold first-line adjustment, press the Micro ↑ key, then go to step 1. - or - Rear Fanfold Forms Path - To advance to the rear, fanfold first-line adjustment, press the Load/Form Feed key. Go to step 10 on page 177. LOAD PAPER 1. Install fanfold paper in the front tractor assembly. 2. Press the Micro ↑ key. 3. The following message will display: + F.FR XXX - 4. A block of Es will be printed on the first print-line. The paper will feed to a position for viewing. Note the position of the first print-line on the paper. The Es should be completely on the paper. The top of the Es should be approximately 1 mm (0.04 in.) below the perforation. 5. The following message will display: PRESS A KEY 6. Press any key to feed the paper back into the printer. The following message will display : YESNO If the first print-line adjustment is correct, press the Micro ↑ key to store the first print-line position. Continue with step 9. - or - Chapter 2. Diagnostics 176