IBM 4247-003 Maintenance Manual - Page 533

Table 107. Selecting Path for Special Forms Types Forms Type Front Push Rear Rear Pull Push Black-Back Forms X Labels X X 1-Part to 4-Part X X X 5-Part to 8-Part X X Greater than 21 lb X X Greater than 0.014 in. thick X X Prenumbered Forms X X Critical Registration X Push Pull X X X X X X Form stock with stick-on X card or form, or forms of varying thickness Note: This printer does not support the following types of forms: Greater than 8-part forms Greater than 40 lb paper Greater than 0.64 mm (0.025 in.) total forms thickness Less than 15 lb paper Less than 0.08 mm (0.003 in.) paper thickness Manual Sheet Comments Feed X For front push, do not use Park X X X X Easiest to load in front push. Set PERF SAFE=YES for 8-part forms X If multiple thicknesses on each sheet, remove Paper Bail Other Considerations for Forms Consider the following items, unless Table 106 or Table 108 provides other direction. v IBM recommends you test the Park function when you intend to run multiple-part forms. If you notice forms feed problems, try using the Eject function. If using the Eject function is ineffective, disable the Park function, and use the push pull forms path. Appendix B. Supplies, Forms, Paths, & Environmental Considerations 533