IBM 4247-003 Maintenance Manual - Page 95

Table 13. MAP 0170: ASF Stacker (continued) Step Questions/Actions Yes 3. The stacker has a motor that transfers the stacker Go to step 4 on page 96. vane. When ASF or manual sheet feed configurations are used, the stacker vane will be in the down position to guide the paper into the stacker. When fanfold push configurations are used, the stacker vane will be in the up position to allow the paper to bypass the stacker. Power on (|) the printer. Feed forms from a push or pull tractor configuration, then feed paper from the ASF or the manual sheet feed tray and observe the stacker vane. Stacker Vane In ASF/Single Sheet Feed Mode (Down Position) Approximately 14 mm Between Vane and Pin 2 to 3 mm Between Vane and Pin Stacker Vane In Fanfold Feed Mode (Up Position) Does the vane transfer OK? No Install a new stacker. - or - Install a new logic board. For Model A00, see "Logic Board Model A00" on page 370. For Models 001 and 002, see "Logic Board - Models 001 and 002" on page 378. Or "Logic Board Model 003" on page 366. - or - Install a new stacker cable. Feed forms alternately from a continuous and a cut sheet path, and observe the stacker vane. Run T&D in Automatic Test Mode to verify correct printer operation. For Model A00, see "How To Run the Test and Diagnostic (T&D) Programs" on page 161. For Models 001, 002, or 003, see "How To Run the Test and Diagnostic (T&D) Programs" on page 201. Chapter 1. Diagnosing Problems 95