IBM 4247-003 Maintenance Manual - Page 180
T&D17 - Tear-Off Line Adjustment Test, If the display is the following
View all IBM 4247-003 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 180 highlights
Note: X can be any number between -6 and +6. 7. If the I is closer to the left leg of the H, decrease the number. If the I is closer to the right leg of the H, increase the number. Press the Micro ↑ key for a positive value. Press the Load/Form Feed key for a negative value. The range is -6 to +6. Each unit is 0.212 mm (0.0083 in. or approximately 1/120 in.). 8. Press the Micro ↓ key to print the new adjustment. See step 2. 9. If an error message is displayed, go to "T&D Error Messages and Actions" on page 190. 10. The test completed successfully if the display advances to the next test number. T&D17 - Tear-Off Line Adjustment Test This test allows you to adjust the tear-off position from the operator panel. The value set by this test becomes the tear-off position when the configuration menu item Tear Adjustment is set to 0 at the operator panel. If the display is the following, go to "T&D11 - Pinch Roller Status/Sensor Tuning/Ribbon Feed and Lift Motors" on page 168. PINCH XXXXX Note: XXXXX is CLOSE or OPEN. Return here after the sensors are tuned. Continue with the next step when the following message displays: YES T.FR ADJ? NO Note: T.FR ADJ is Tear-Off line FRont tractor ADJustment 1. To select the front fanfold tear-off adjustment, press the Micro ↑ key, and go to step 3. Chapter 2. Diagnostics 180