IBM 4247-003 Maintenance Manual - Page 215
Line Feed, Start, To adjust the first print-line for the front tractor feed, press
![]() |
View all IBM 4247-003 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 215 highlights
8. If an error message is displayed, go to "T&D Error Messages and Actions - Models 001, 002, and 003" on page 231. 9. The test completed successfully if the display advances to the next test number. T&D15 - First Printing Line Adjustment Test This test allows you to adjust the first print-line for the front fanfold forms path and the rear fanfold forms path from the operator panel. The value set by this test becomes the first print-line position when the configuration menu item Paper Load Position is set to 0. Note: If you adjust this value you also must run T&D17 1. Display: T&D15 First Printing Line Adjustment Test RUN TEST ? YES END NO 2. Press the Line Feed key. If the following message displays, go to "T&D11 - Pinch Roller/Sensor Tune/Ribbon Feed and Lift Motors" on page 208. T&D15 First Printing Line Adjustment Test STORED PINCH XXXXX PRESS A KEY Return here after the sensors are tuned. Continue with the next step when the printer displays: T&D15 First Printing Line Adjustment Test FANFOLD FRONT ADJ? YES NO 3. To adjust the first print-line for the front tractor feed, press the Line Feed key. The test will automatically advance to the rear first print-line adjustment after you complete the front. 4. If you want to advance to the rear first print-line adjustment, now, press the Start key. The procedure to adjust either front or rear first print-line is the same. Chapter 2. Diagnostics 215
![](/manual_guide/products/ibm-4247003-maintenance-manual-ab6123f/215.png)