IBM 4247-003 Maintenance Manual - Page 113

Table 15. MAP 0190: Forms Feed Problems (continued) Step Questions/Actions 18. Make the following checks: a. Forms input and output stacking follows the recommendations in "Forms Stacking Recommendations" on page 539. b. Input forms are aligned to feed straight into the printer. c. Input forms are not catching on the edge of the forms carton. d. Printer is properly positioned on the work surface (front edge of the printer at the front edge of the work surface) to provide unrestricted forms feed for front push, push-pull, and rear pull forms paths. Note: If there is a feed problem with the rear push forms path, position the rear edge of the printer at the rear edge of the work surface. e. Forms tension between the left and right tractors is properly adjusted. Yes Go to step 19 on page 114. No Repair, as needed. Run T&D in automatic mode to verify correct printer operation. For Model A00, see "How To Run the Test and Diagnostic (T&D) Programs" on page 161. For Models 001, 002, or 003, see "How To Run the Test and Diagnostic (T&D) Programs" on page 201. Continue with step 12 on page 110. Left Margin Right Margin Left Margin Right Margin Correct Incorrect f. Forms meet specifications described in "Appendix B. Supplies, Forms, Paths, & Environmental Considerations" on page 531. g. Label forms meet specifications described in "Appendix B. Supplies, Forms, Paths, & Environmental Considerations" on page 531. h. The environment meets the specifications described in "Environmental Requirements" on page 546. Are the checks OK? Chapter 1. Diagnosing Problems 113