IBM 4247-003 Maintenance Manual - Page 144

Table 18. Error Messages for Models 001, 002, and 003 (continued) Message Description Action 201 NO ATTACHMENT CARD FOUND MODEL 003 TWINAX CODE SEE USER'S GUIDE A serial, LAN, or twinax attachment card 1. If attachment card was removed, was not found during the current power on, confirm this by pressing the start key. but was previously. 2. Otherwise, power off the printer and reseat the attachment card. 202 NEW ATTACHMENT CARD FOUND DIAGNOSTIC IN PROGRESS PLEASE WAIT (flashing) MODEL 003 A new type of attachment card was found Press Start to confirm installing a new during the current power on. This will occur attachment card and to continue power on on the first power-on following the initialization. After the code transfer is installation of a new card. complete, Coax or Twinax will be displayed on the operator's panel. SEE USER'S GUIDE 203 ATTACHMENT CARD FAILURE MODEL 003 SEE USER'S GUIDE An error occurred during attachment card 1. Reflash the basecode. See flash memory power on initialization. The "Appendix C. Flashing the Memory of problem may be from the base code, the the Model 003" on page 549. attachment card, the attachment card interposer connector, or the logic board. 2. If error reoccurs, replace the attachment card. See "Model 003 See "T&D30 - Adapter Board Link Test" on page 227. Attachment Cards: Serial, Twinax, LAN, Coax" on page 359. a. If you are having difficulty physically installing the attachment card, inspect the attachment card guide assembly and the interposer connector for damage. Replace if necessary. See "Attachment Card Guide Assembly with the Interposer Connector (Model 003)" on page 364. 3. If error reoccurs, replace logic board, see "Logic Board - Model 003" on page 366. Chapter 1. Diagnosing Problems 144