IBM 7014-T42 User Guide - Page 33

Removing and replacing 7014-T00 or 7014-T42 side panels

Get IBM 7014-T42 PDF manuals and user guides View all IBM 7014-T42 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 33 highlights

2 Terminal block (both sides) 3 Power distribution panel 4 Front of rack Figure 18. Reinstalling the cable channel cover Removing and replacing 7014-T00 or 7014-T42 side panels Learn how to remove and replace a side panel on a rack. Use the procedures in this section to perform this task. Removing a 7014-T00 or 7014-T42 side panel: Use the procedure in this section to remove a side panel on a rack. To remove a side panel, complete the following steps: 1. Unlock the side panels by pressing down on both locking latches to release the latches. Figure 19. Removing the side panel Note: If your rack uses a ruggedized kit, you must remove the securing screw to allow each side panel to be removed. See "Releasing the side panel with a ruggedized kit" on page 32. 2. Tilt the top of the side panel slightly toward you. 3. Lift the side panel away from the ridge on the bottom of the rack. 4. Repeat this procedure for the other side panel. Racks and rack features 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
2
Terminal block (both sides)
3
Power distribution panel
4
Front of rack
Removing and replacing 7014-T00 or 7014-T42 side panels
Learn how to remove and replace a side panel on a rack. Use the procedures in this section to perform
this task.
Removing a 7014-T00 or 7014-T42 side panel:
Use the procedure in this section to remove a side panel on a rack.
To remove a side panel, complete the following steps:
1.
Unlock the side panels by pressing down on both locking latches to release the latches.
Note:
If your rack uses a ruggedized kit, you must remove the securing screw to allow each side
panel to be removed. See “Releasing the side panel with a ruggedized kit” on page 32.
2.
Tilt the top of the side panel slightly toward you.
3.
Lift the side panel away from the ridge on the bottom of the rack.
4.
Repeat this procedure for the other side panel.
Figure 18. Reinstalling the cable channel cover
Figure 19. Removing the side panel
Racks and rack features
21