IBM 7014-T42 User Guide - Page 38
Rack safety notices, If you are installing equipment into a non-IBM rack - rack specifications
View all IBM 7014-T42 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Figure 24. Removing the trim panels 1 Rack chassis 2 Top trim panel 3 Left-side trim panel 4 Right-side trim panel 5 Spring clip 3. Install the door latch on the right and the door hinges on the left. 4. For a high-perforation front door, align the door over the rack hinge, then move up the hinge pin on the door, and lower the hinge pin into the hinge. 5. Adjust the latch so the door latches securely. Rack safety notices: You need to read the rack safety notices before installing equipment. Before installing a rack, rack features, or a system or expansion unit into a rack, read the following safety information. Attention: If you are installing equipment into a non-IBM rack, the rack must comply with the Electronics Industries Association (EIA) 310D specifications. If you do not have a rail kit designed for the equipment in the non-IBM rack, do not install the equipment into the rack as damage to the equipment or personal injury could occur. 26 Power Systems: Racks and rack features