IBM 88631SU Service Guide - Page 118
Solving, problems, power
UPC - 000435913135
View all IBM 88631SU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 118 highlights
Solving SCSI problems Note: This section also applies to Serial Attached SCSI (SAS) problems. For any SCSI error message, one or more of the following devices might be causing the problem: v A failing SCSI device (adapter, drive, or controller) v An incorrect SCSI termination jumper setting v Duplicate SCSI IDs in the same SCSI chain v A missing or incorrectly installed SCSI terminator v A defective SCSI terminator v An incorrectly installed cable v A defective cable For any SCSI error message, follow these suggested actions in the order in which they are listed until the problem is solved: 1. Make sure that external SCSI devices are turned on before you turn on the server. 2. Make sure that the cables for all external SCSI devices are connected correctly. 3. If an external SCSI device is attached, make sure that the external SCSI termination is set to automatic. 4. Make sure that the last device in each SCSI chain is terminated correctly. 5. Make sure that the SCSI devices are configured correctly. Solving power problems Power problems can be difficult to solve. For example, a short circuit can exist anywhere on any of the power distribution buses. Usually, a short circuit will cause the power subsystem to shut down because of an overcurrent condition. Use the following general procedure for diagnosing a power problem: 1. Turn off the server and disconnect all ac power cords. 2. Check for loose cables in the power subsystem. Also check for short circuits, for example, if a loose screw is causing a short circuit on a circuit board. 3. Remove the adapters and disconnect the cables and power cords to all internal and external devices until the server is at the minimum configuration that is required for the server to start (see "Minimum operating requirements" on page 104). 4. Reconnect all ac power cords and turn on the server. If the server starts successfully, replace the adapters and devices one at a time until the problem is isolated. If the server does not start from the minimum configuration, replace the components in the minimum configuration one at a time until the problem is isolated. To use this method, you must know the minimum configuration that is required for the server to start (see "Solving undetermined problems" on page 104). 102 IBM System x3850 Type 8863, 7362: Problem Determination and Service Guide