IBM 88631SU Service Guide - Page 32
replaceable - memory configuration
UPC - 000435913135
View all IBM 88631SU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved. v See Chapter 3, "Parts listing, Type 8863, 7362," on page 107 to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU). v If an action step is preceded by "(Trained service technician only)", that step must be performed only by a trained service technician. Beep code Description Action 3-3-3 No operational memory in system. Note: Make sure you re-enable the memory in the Configuration/Setup Utility program. See, "Memory problems" on page 52 1. Make sure that all memory cards contain the correct number of DIMMs; install or reseat DIMMS; then, restart the server. 2. Reseat the following components: a. DIMM b. Memory card c. Microprocessor tray 3. Replace the following components one at a time, in the order shown, restarting the server each time. a. DIMM b. Memory card c. (Trained service technician only) Microprocessor tray Two short beeps Information only, configuration has changed. 1. Run the Configuration/Setup Utility program. 2. Run the diagnostic programs. Three short beeps Memory error. Note: Make sure you re-enable the memory in the Configuration/Setup Utility program. See, "Memory problems" on page 52 1. Reseat the following components: a. DIMM b. Memory card c. Microprocessor tray 2. Replace the following components one at a time, in the order shown, restarting the server each time. a. DIMM b. Memory card c. (Trained service technician only) Microprocessor tray 16 IBM System x3850 Type 8863, 7362: Problem Determination and Service Guide