IBM 88631SU Service Guide - Page 95
logical
![]() |
UPC - 000435913135
View all IBM 88631SU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved. v See Chapter 3, "Parts listing, Type 8863, 7362," on page 107 to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU). v If an action step is preceded by "(Trained service technician only)", that step must be performed only by a trained service technician. Error code Description Action 089-xxx-0nn Failed microprocessor test, where nn=APIC ID. APIC ID (physical mode) Microprocessor 00, 01, 02, 03 1 04, 05, 06, 07 2 10, 11, 12, 13 3 14, 15, 16, 17 4 APIC ID (logical mode) Microprocessor 1. Reseat the following components: a. (Trained service technician only) Microprocessor nn b. Microprocessor tray 2. Replace the following components one at a time, in the order shown, restarting the server each time. a. (Trained service technician only) Microprocessor nn b. (Trained service technician only) Microprocessor tray 00, 01, 02, 03 1 24, 25, 26, 27 2 10, 11, 12, 13 3 155-xxx-xxx 34, 35, 36, 37 4 Failed Active Memory™ latch test. Note: Make sure you re-enable the memory in the Configuration/Setup Utility program. See, "Memory problems" on page 52 1. Reseat the memory card. 2. Replace the memory card. 166-051-000 System Management: Failed. Unable to communicate with ASM. It may be busy. Run the test again. 1. Update the firmware (BIOS, service processor, and diagnostics; see "Updating the firmware" on page 147). 2. Run the diagnostic test again. 3. Correct other error conditions (including failed systems-management tests and items that are logged in the Remote Supervisor Adapter II SlimLine system-error log) and retry. 4. Disconnect all server and option power cords from the server, wait 30 seconds, reconnect the power cords, and retry. 5. Reseat the Remote Supervisor Adapter II SlimLine. 6. Replace the Remote Supervisor Adapter II SlimLine. Chapter 2. Diagnostics 79
![](/manual_guide/products/ibm-88631su-service-guide-767fd05/95.png)