IBM 88631SU Service Guide - Page 149
board
UPC - 000435913135
View all IBM 88631SU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 149 highlights
I/O board 2. Connect the light path diagnostics ribbon cable and front USB cable to the I/O board. 3. Slide the front-panel assembly into the server until the blue tab on the chassis engages. 4. Replace the bezel and top cover. 5. Reconnect external cables and power cords. When replacing the I/O board, you must either update the server with the latest SAS firmware or restore the pre-existing firmware from a diskette or CD image. The I/O board contains three-pin jumper blocks. See "I/O board internal connectors and jumpers" on page 8 for the location and description of each jumper block. Replacing the I/O board To remove the I/O board, complete the following steps. DCAC 1. Read the safety information that begins on page vii, and "Handling static-sensitive devices" on page 114. 2. Turn off the server and peripheral devices, and disconnect the power cords and all external cables necessary to replace the device. 3. Remove the top cover. Attention: When moving the I/O board, do not allow it to impact any components or structures inside the server. 4. Open the release latches on both ends of the I/O board and pull the board from the server slightly. Chapter 4. Removing and replacing server components 133