IBM 88631SU Service Guide - Page 170
Using, SAS/SATA, Configuration, Utility, program, Configuring, Ethernet, controller, agent, utility
UPC - 000435913135
View all IBM 88631SU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 170 highlights
Use the baseboard management controller firmware update utility program to download a baseboard management controller firmware update. The firmware update utility program updates the baseboard management controller firmware and does not affect any device drivers. Go to http://www.ibm.com/support/ to download the utility program; then, copy the Flash.exe file to a firmware update diskette. Note: To ensure proper server operation, be sure to update the server baseboard management controller firmware before updating the BIOS code. Using the SAS/SATA Configuration Utility program Use the SAS/SATA Configuration Utility program to view or change SAS controller settings. Complete the following steps to start the SAS/SATA Configuration Utility program: 1. Turn on the server. 2. When the message Press for Adaptec SAS/SATA Configuration Utility appears, press Ctrl+A. If an administrator password has been set, you are prompted to type the password. 3. Follow the instructions on the screen to configure the controller settings. Go to http://www.ibm.com/support/ to check for the latest version of the SAS firmware. Configuring the Ethernet controller The Ethernet controller is integrated on the system board. It provides an interface for connecting to a 10-Mbps, 100-Mbps, or 1-Gbps network and provides full-duplex (FDX) capability, which enables simultaneous transmission and reception of data on the network. If the Ethernet ports in the server support auto-negotiation, the controller detects the data-transfer rate (10BASE-T, 100BASE-TX, or 1000BASE-T) and duplex mode (full-duplex or half-duplex) of the network and automatically operates at that rate and mode. You do not have to set any jumpers or configure the controller. However, you must install a device driver to enable the operating system to address the controller. For device drivers and information about configuring the Ethernet controller, see the Broadcom NetXtreme Gigabit Ethernet Software CD that comes with the server. For updated information about configuring the controller, go to http://www.ibm.com/ support/. Using the PXE boot agent utility program The Preboot Execution Environment (PXE) boot agent utility program is part of the BIOS code. You can use it to specify the startup order of devices and enable or disable operating-system wake-up support. Note: The server does not support changing the network boot protocol or specifying the startup order of devices through the PXE boot agent utility program. Complete the following steps to start the PXE boot agent utility program: 1. Turn on the server. 2. When the Initializing Intel (R) Boot Agent Version X.X.XX PXE 2.0 Build XXX (WfM 2.0) prompt appears, press Ctrl+S. You have 2 seconds (by default) 154 IBM System x3850 Type 8863, 7362: Problem Determination and Service Guide