IBM 88631SU Service Guide - Page 132
information, Battery
UPC - 000435913135
View all IBM 88631SU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 132 highlights
4. Lift the cover-release latch. The cover slides to the rear approximately 13 mm (0.5 inch). Lift the cover off the server. Attention: For proper cooling and airflow, replace the top cover before turning on the server. Operating the server for more than 2 minutes with the top cover removed might damage server components. 5. Press on the bezel retention tabs at the top edge of the bezel, and pull the top of the bezel slightly away from the server. 6. Lift the bezel up to release the tabs at the bottom edge of the bezel. Tier 1 CRU information Installation of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at your request, you will be charged for the installation. Battery The following notes describe information that you must consider when replacing the battery in the server. v When replacing the battery, you must replace it with a lithium battery of the same type from the same manufacturer. v To order replacement batteries, call 1-800-772-2227 within the United States, and 1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada, call your IBM reseller or IBM marketing representative. v After you replace the battery, you must reconfigure the system and reset the system date and time. v To avoid possible danger, read and follow the following safety statement. Statement 2: CAUTION: When replacing the lithium battery, use only IBM Part Number 33F8354 or an equivalent type battery recommended by the manufacturer. If your system has a module containing a lithium battery, replace it only with the same module type made by the same manufacturer. The battery contains lithium and can explode if not properly used, handled, or disposed of. Do not: v Throw or immerse into water v Heat to more than 100°C (212°F) v Repair or disassemble Dispose of the battery as required by local ordinances or regulations. Complete the following steps to replace the battery: 1. Read the safety information that begins on page vii, and "Handling static-sensitive devices" on page 114, and follow any special handling and installation instructions supplied with the replacement battery. 2. Turn off the server and peripheral devices, and disconnect the power cords and all external cables necessary to replace the device. 116 IBM System x3850 Type 8863, 7362: Problem Determination and Service Guide