IBM JS20 User Guide - Page 45
Input/output, connectors, devices
![]() |
UPC - 000435230263
View all IBM JS20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
9. If this is not the initial installation of this blade server in the BladeCenter unit, continue with the next step. If this is the initial installation of this blade server in the BladeCenter unit, you must perform the following additional tasks: a. Configure the BladeCenter unit for Serial Over LAN (SOL) support (see the IBM BladeCenter and BladeCenter T Serial Over LAN Setup Guide). b. Turn on the blade server by pressing the power-control button on the blade server control panel. The power-on LED on the blade server changes from the slowly-flashing state to a continuously lit (steady) state. c. Establish a Telnet connection and an SOL session to enable communication between the blade server and a monitor, keyboard, and mouse. The BladeCenter unit contains a video connector for attaching a monitor. However, the blade server does not contain a video controller. You must establish an SOL connection to the blade server for console output. You can do this remotely through a separate client system that uses the Telnet program. For additional information about SOL requirements, see the IBM BladeCenter and BladeCenter T Serial Over LAN Setup Guide. For additional information about monitors, see the BladeCenter unit Installation and User's Guide. d. Install the operating system. Use the installation instructions that come with the operating system, or download the latest operating-system installation instructions from the IBM Support Web page at http://www.ibm.com/ support/. For more information, see Chapter 6, "Installing the operating system," on page 45. 10. If you have already installed the operating system on the blade server, configured the BladeCenter components for SOL support, and established an SOL session, the blade server is ready to use. If you have not already done so, turn on the blade server by pressing the power-control button on the blade server control panel. The power-on LED on the blade server changes from the slowly-flashing state to a continuously lit (steady) state. 11. If you have other blade servers to install, you can do so now. Input/output connectors and devices The BladeCenter unit contains the input/output connectors that are available to the blade server. See the documentation that comes with the BladeCenter unit for information about the input/output connectors. The blade server does not support a direct connection to a monitor, keyboard, or mouse. Therefore, to enable communication between the blade server and these devices, you must perform the configuration tasks that are described in Chapter 5, "Configuration requirements for the blade server," on page 35 and the IBM BladeCenter and BladeCenter T Serial Over LAN Setup Guide. Chapter 4. Installing options 33
![](/manual_guide/products/ibm-js20-user-guide-5dc2616/45.png)