IBM JS20 User Guide - Page 48
Using, Serial, feature, blade, server
![]() |
UPC - 000435230263
View all IBM JS20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
6. Click Continue. A list of the available BladeCenter documentation will be displayed under the heading Results by date. Using the Serial Over LAN (SOL) feature on the blade server In addition to performing the configuration tasks in this chapter, you must perform the following SOL tasks. These tasks are described in the IBM BladeCenter and BladeCenter T Serial Over LAN Setup Guide: v Update and configure BladeCenter components for SOL operation using the management-module Web-based management and configuration program v Configure the BladeCenter unit to operate using SOL v Enable the SOL feature for the blade server v Establish an SOL connection The blade server has built-in support for the SOL feature. However, the SOL feature works only if it is enabled for the BladeCenter unit and the blade server. If the SOL feature is not already enabled for the blade server, you must enable the SOL feature. You must establish an SOL connection and start an SOL session on the blade server before you can perform the following activities: v Establish a communications channel to the blade server v Install the operating system on the blade server v Have the blade server serviced To support the SOL feature and to make sure that your blade server is correctly auto-configured, you must install a compatible Ethernet switch module in I/O bay 1 of the BladeCenter unit. Examples of compatible Ethernet switch modules are the IBM 4-Port Gb Ethernet Switch Module for BladeCenter and the Nortel Networks Layer 2-7 GbE Switch Module for IBM BladeCenter. For more information about installing, configuring, and using these switch modules, see the following documentation: v IBM 4-Port Gb Ethernet Switch Module for BladeCenter Installation and User's Guide v Nortel Networks Layer 2-7 GbE Switch Module for IBM BladeCenter Installation Guide v BladeCenter and BladeCenter T Management Module Command-Line Interface Reference Guide v IBM BladeCenter and BladeCenter T Serial Over LAN Setup Guide The SOL feature is accessed through the management-module command-line interface. For information about using the command-line interface, see the BladeCenter and BladeCenter T Management Module Command-Line Interface Reference Guide. Notes: v The BladeCenter unit needs to be configured only once. v If your blade server contains a different type of optional Ethernet-compatible switch module in I/O bay 1 than the switch modules that are mentioned in this chapter, see the documentation that comes with the Ethernet switch module that you are using. 36 BladeCenter JS20 Type 8842: Installation and User's Guide
![](/manual_guide/products/ibm-js20-user-guide-5dc2616/48.png)