IBM JS20 User Guide - Page 73
information.
![]() |
UPC - 000435230263
View all IBM JS20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Checkpoint code E210 E211 E212 E213 E214 E215 E216 Description Load and relocate the hardware isolation layer (HIL). CRC check of the image in flash RAM. Get processor status and presence. Memory initialization. Pattern 1 memory test. Pattern 2 memory test. Clear memory. Suggested action 1. Perform the system checkout procedure. See "System checkout" on page 48. 2. This error indicates that you might have a problem with the system board. Contact a service support representative for more information. 1. Perform the system checkout procedure. See "System checkout" on page 48. 2. This error indicates that you might have a problem with the system board. Contact a service support representative for more information. 1. Perform the system checkout procedure. See "System checkout" on page 48. 2. This error indicates that you might have a problem with the system board. Contact a service support representative for more information. 1. Make sure that the DIMMs are correctly installed and seated; then, restart the blade server. 2. Start the blade server from the PERM flash image to recover the TEMP image. See "Recovering the system firmware code" on page 84. 3. This error indicates that you might have a problem with the system board. Contact a service support representative for more information. 1. Make sure that the DIMMs are correctly installed and seated; then, restart the blade server. 2. Start the blade server from the PERM flash image to recover the TEMP image. See "Recovering the system firmware code" on page 84. 3. This error indicates that you might have a problem with the system board. Contact a service support representative for more information. 1. Make sure that the DIMMs are correctly installed and seated; then, restart the blade server. 2. Start the blade server from the PERM flash image to recover the TEMP image. See "Recovering the system firmware code" on page 84. 3. This error indicates that you might have a problem with the system board. Contact a service support representative for more information. 1. Make sure that the DIMMs are correctly installed and seated; then, restart the blade server. 2. Start the blade server from the PERM flash image to recover the TEMP image. See "Recovering the system firmware code" on page 84. 3. This error indicates that you might have a problem with the system board. Contact a service support representative for more information. Chapter 7. Solving problems 61
![](/manual_guide/products/ibm-js20-user-guide-5dc2616/73.png)