IBM JS20 User Guide - Page 71
IBM JS20 - BladeCenter - 8842 Manual
UPC - 000435230263
View all IBM JS20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Checkpoint code E1FB E1FC E1FD E1FE E1FF E199 E200 E201 E202 Description Suggested action Reserved Have the blade server serviced. Build the boot list for serial storage architecture (SSA) adapters. The location code of the SSA adapter being scanned is also displayed. 1. Perform the system checkout procedure. See "System checkout" on page 48. 2. This error indicates that you might have a problem with the system board. Contact a service support representative for more information. E1FD and another progress code (Exxx) will alternate in the operator panel. The other code indicates where the error occurred. 1. Perform the system checkout procedure. See "System checkout" on page 48. 2. This error indicates that you might have a problem with the system board. Contact a service support representative for more information. Build the boot list for Fibre Channel 1. Perform the system checkout procedure. See adapters. The world-wide port "System checkout" on page 48. number (WWPN) of the SAN adapter being scanned is also displayed. 2. This error indicates that you might have a problem with the system board. Contact a service support representative for more information. Building the boot list for Fibre 1. Perform the system checkout procedure. See Channel adapters. The WWPN of the "System checkout" on page 48. SAN adapter being scanned is also displayed. 2. This error indicates that you might have a problem with the system board. Contact a service support representative for more information. Restarting (rebooting) the partition to activate the changes that are specified in the boot-image's executable and linkable format (ELF) header. 1. Check the http://www.ibm.com/support Web site for a later firmware version that might address the problem. For additional information, see "Updating the firmware code for the blade server and the service processor" on page 40. 2. If a later firmware version is not available, or if the problem remains after you update the firmware code, go to the "Boot problem resolution" section in the BladeCenter JS20 Type 8842 Hardware Maintenance Manual and Troubleshooting Guide. Follow the instructions in that section. I2C bus controller initialization. 1. Perform the system checkout procedure. See "System checkout" on page 48. 2. If the problem remains, force the system to start from the PERM flash image to reflash the TEMP image for recovery. See "Recovering the system firmware code" on page 84. 3. If the problem remains, replace the blade server. Contact a service support representative for assistance. The flash random-access memory (RAM) cyclic redundancy check (CRC) checksum is valid. 1. Perform the system checkout procedure. See "System checkout" on page 48. 2. This error indicates that you might have a problem with the system board. Contact a service support representative for more information. Programmable interrupt controller (MPIC) initialization. 1. Perform the system checkout procedure. See "System checkout" on page 48. 2. This error indicates that you might have a problem with the system board. Contact a service support representative for more information. Chapter 7. Solving problems 59