Intel S1200RP Service Guide - Page 56
Installing 8x3.5 Hot-swap Hard Drive Cage with Backplane
View all Intel S1200RP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Server Utilities 6. Use screwdriver to release the hot-swap hard drive cage (see letter A) from the chassis and remove the hot-swap hard drive cage (see letter B). Figure 66. Removing the 8x3.5" HDD Cage Installing 8x3.5" Hot-swap Hard Drive Cage with Backplane CAUTION It is critical that you connect the SAS/SATA data cables correctly from the SAS/SATA backplane to your server board or RAID controller card. Failure to do so may result in data loss. 1. Observe the safety and ESD precautions at the beginning of this manual. 2. Power down the server and unplug all peripheral devices and the AC power cable. 3. Remove the chassis cover. For instructions, see Removing the System Side Cover. 4. Remove the front bezel if it is installed. For instructions, see "Removing the Front Bezel". 5. Install the 8x3.5" Hot-Swap Hard Drive Cage. 1) Slide the 8x3.5" Hot-Swap Drive Cage into the slot (see letter A). 2) Secure the Hard Drive Cage with the Screws (see letter B). Intel® Server System P4000RP Family Service Guide 43