JVC HM-DH30000UP 84 pg. instruction manual on the HM-DH30000U D-VHS recorder/p - Page 68

68 EN MULTI-BRAND REMOTE CONTROL (cont.) DBS Receiver Brand Setting 2 VCR TV CABLE/DBS 1 2 3 4 5 6 7 8 9 0 3 -13 POWER ENTER 3 -2 Number 3 -3 TV CH +/- This Remote can control some functions of the DBS (Direct Broadcast Satellite) receivers listed below. 1 Turn on the DBS receiver Turn on the DBS receiver using the Power button on the DBS receiver or its Remote. 2 Set remote operation mode Set the VCR/TV/CABLE/DBS selector to "CABLE/ DBS". 3 Enter DBS receiver brand code Follow the example shown below. 1 Press and hold POWER. 2 Press the Number keys to enter your DBS receiver's brand code by referring to the table below. 3 Press STOP ( 7 ), and release POWER. ● Once you have set the Remote to operate the DBS receiver, you do not have to set it until you replace the batteries from the Remote. 4 Operate DBS receiver First set the VCR/TV/CABLE/DBS selector to "CABLE/DBS", then press one of the following buttons: POWER, TV CH +/-, and Number keys. ● For some brands, you must press ENTER after having pressed the Number keys to enter a channel number. ● To change the DBS receiver's channels, press TV CH +/- or the Number keys. (The CH +/- button can be used to change the VCR's channels only.) ● To operate the VCR, set the VCR/TV/CABLE/ DBS selector back to "VCR". DBS BRAND NAME JVC (DISH Network) ECHOSTAR (DISH Network) PRIMESTAR SONY (DSS) RCA (DSS) BRAND CODE 51 51 50 41 40 NOTES: ● Depending on the type of DBS receiver, some or all functions cannot be operated using this Remote. ● It's not possible to operate a DBS receiver not equipped with a remote sensor. ● It's not possible to set the Remote for both your DBS receiver and a cable box at the same time. You can only set the Remote to operate one of these units at a time. (Ex.) To set the Remote to JVC 51: POWER 5 1 JKL . , ? STOP Hold down Press in succession Release