Kyocera C8100DN Command Center Guide - Page 41
Advanced > Protocols > TCP/IP > Logical Printers, Description, IP Filter IPv4, IP Address
View all Kyocera C8100DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
COMMAND CENTER Pages If nothing is specified on this page, access from all hosts is allowed. Item Description IP Filter (IPv4) IP Address (IPv4) Specifies the IP address or network address to be permitted. The number of specifiable entries differs depending on models. Subnet Mask Specifies the subnet mask to be permitted. To permit access from all hosts on network 192, enter "192.0.0.0" for the IP address and "255.0.0.0" for the subnet mask. Subnet mask can be left blank. Protocols Specifies the protocol to be permitted. The following protocols can be selected. - LPD - FTP - IPP - HTTP - SNMP - RAW Port - IPP over SSL - HTTPS IP Filters (IPv6) IP Address (IPv6) Specifies the IP addresses to which access is granted. The number of addresses that can be specified varies depending on the model used. Prefix Length Specifies the IPv6 prefix length. It can be a decimal value between 0 and 128. Protocols Specifies the protocols through which access is granted.The following protocols can be selected. - LPD - FTP - IPP - HTTP - RAW Port - SNMP Advanced > Protocols > TCP/IP > Logical Printers This page allows you to configure the Logical Printers. This machine can be used as a virtual printer for converting ASCII print data to PostScript data or for adding and/or replacing a character strings (commands) at the beginning or end of job data. Up to four logical printers can be set. Operation Guide 37