Lenovo ThinkServer RD240 MegaRAID SAS Software User Guide - Page 154

Table 4.2 Controller Properties Menu Options (Cont.) Option Spinup Delay StopOnError Drive Powersave Description Use this option to control the interval (in seconds) between spinup of drives connected to this controller. The delay prevents a drain on the system's power supply that would occur if all drives spun up at the same time. The default is 12 seconds. Enable this option if you want the boot process to stop when the controller BIOS encounters an error during boot-up. The default is Disabled. Drive Powersave conserves energy by placing certain unused drives into powersave mode. Use this field to choose whether to allow unconfigured drives to enter powersave mode. Connector 2 Stop CC on Error Maintain PD Fail History Schedule CC When this option is selected, unconfigured drives may be spun down. When not selected, these drives are not spun down. The controller will automatically spin up drives from powersave mode whenever necessary. The powersave option is not selected by default. You have to select it to enable the spin-down of drives. Identifies where the chain of enclosures is connected to the RAID controller. Enable this option if you want to stop a consistency check when the controller BIOS encounters an error. The default is No. Enable this option to maintain the history of all drive failures. The default is Enabled. Indicates whether the option to schedule the date and time for a consistency check is supported. If you make changes to the options on this screen, click Submit to register them. If you change your mind, click Reset to return the options to their default values. 4.6.2 Viewing and Changing Virtual Drive Properties Access the Virtual Drive screen by clicking on a virtual drive in the list of virtual drives in the right panel on the WebBIOS CU main screen. The Virtual Drive screen displays, as shown in Figure 4.50. 4-78 WebBIOS Configuration Utility