Lenovo ThinkServer RD240 MegaRAID SAS Software User Guide - Page 188

Table 5.24 Set BBU Properties Convention Description MegaCli -AdpBbuCmd -SetBbuProperties -f -aN|-a0,1,2|-aALL Sets the BBU properties on the selected controller(s) after reading from the file. The information displays in the following formats: autoLearnPeriod = 1800Sec nextLearnTime = 12345678Sec Seconds past 1/1/2000 learnDelayInterval = 24hours Not greater than 7 days autoLearnMode = 0 0 - Enabled, 1 - Disabled, 2 - WarnViaEvent. 1. NOTE: You can change only two of these parameters, learnDelayInterval and autoLearnMode. 5.8 Options for Displaying Logs Kept at Firmware Level Use the commands in this section to select the display settings for the event log and BBU terminal log, which are kept at the firmware level. 5.8.1 Event Log Management Use the command in Table 5.25 to manage the event entries in the event log for the selected controller(s). Table 5.25 Event Log Management Convention MegaCli -AdpEventLog -GetEventlogInfo | -GetEvents {-info -warning critical -fatal} | GetSinceShutdown {-info -warning -critical -fatal} | GetSinceReboot {-info -warning -critical -fatal} | IncludeDeleted {-info -warning -critical -fatal} | {GetLatest {-info warning -critical -fatal} } -f | Clear -aN|-a0,1,2|-aALL | {GetCCIncon} -f -LX| -L0,2,5...|-LALL -aN|-a0,1,2|-aALL 5-18 MegaRAID Command Tool