Lenovo ThinkServer RD240 MegaRAID SAS Software User Guide - Page 183

5.6.1 Set or Display Bootable Virtual Drive ID Use the command in Table 5.15 to set or display the ID of the bootable virtual drive. Note: This option does not write a boot sector to the virtual drive. The operating system will not load if the boot sector is incorrect. Table 5.15 Bootable Virtual Drive ID Convention Description MegaCli -AdpBootDrive {-Set -Lx| -physdrv[E0:S0]}} | -Get -aN|a0,1,2|-aALL Sets or displays the bootable virtual drive ID: -Set: Sets the virtual drive as bootable so that during the next reboot, the BIOS will look for a boot sector in the specified virtual drive. Identifies the physical drive in the virtual drive, by enclosure and slot, to use to boot from. -Get: Displays the bootable virtual drive ID. 5.6.2 Select BIOS Status Options Use the command in Table 5.16 to set the options for the BIOS status. Table 5.16 Options for BIOS Status Convention Description MegaCli -AdpBIOS -Enbl|-Dsbl|-Dsply| SOE | BE -aN|-a0,1,2|-aALL Sets BIOS options. The following are the settings you can select on a single controller, multiple controllers, or all controllers: -Enbl, -Dsbl, -Dsply: Enables, disables or displays the BIOS status on selected controller(s). -SOE: Stops on BIOS errors during POST for selected controller(s). When set to -SOE, the BIOS stops in case of a problem with the configuration. This gives you the option to enter the configuration utility to resolve the problem. This is available only when you enable the BIOS status. -BE: Bypasses BIOS errors during POST. This is available only when you enable the BIOS status. 5.7 Battery Backup Unit-Related Properties You can use the commands in this section to select the settings for BBU-related options. Battery Backup Unit-Related Properties 5-13