Lenovo ThinkServer RD240 MegaRAID SAS Software User Guide - Page 239
Configuring SNMP Traps, or using snmpd.conf file. Following indicators can
![]() |
View all Lenovo ThinkServer RD240 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 239 highlights
- # arguments: community - # [default|hostname|network/bits] [oid] - # rwcommunity snmpclient 172.28.157.149 3. Start the SMA service by using the following command: # svcadm enable svc:/application/management/sma:default Note: Refer to the command man snmpd.conf for more information about configuring the snmpd.conf file. 6.6.2.6 Configuring SNMP Traps To receive SNMP traps, perform the following steps: 1. Stop the ThinkServer SAS SNMP Agent by using the following command: #/etc/init.d/ThinkServer_mrdsnmpd stop 2. Edit the /etc/ThinkServer_mrdsnmp/sas/sas_TrapDestination.conf file and add the ipaddress as shown in the following excerpt Agent Service needs the IP addresses to sent trap - # The trap destination may be specified in this file # or using snmpd.conf file. Following indicators can # be set on "TrapDestInd" to instruct the agent to - # pick the IPs as the destination. - # 1 - IPs only from snmpd.conf - # 2 - IPs from this file only - # 3 - IPs from both the files TrapDestInd 2 Trap Destination IP 127.0.0.1 public - 172.28.157.149 public Installing and Configuring an SNMP Agent 6-31
![](/manual_guide/products/lenovo-thinkserver-rd230-megaraid-sas-software-user-guide-7a323ec/239.png)